About DOE Button Organization Button News Button Contact Us Button
Search  
US Department of Energy Seal and Header Photo
Science and Technology Button Energy Sources Button Energy Efficiency Button The Environment Button Prices and Trends Button National Security Button Safety and Health Button
_DOE Office of Fossil Energy Web Site
You are here:  Educational Activities > Energy Lessons > Coal-Introduction > 3-Knocking Out NOx

An Energy Lesson

Cleaning Up Coal

Knocking the NOx Out of Coal

-

How NOx Forms

-

Formation of NOx

-
Air is mostly nitrogen molecules (green in the above diagram) and oxygen molecules (purple). When heated hot enough (around 3000 degrees F), the molecules break apart and oxygen atoms link with the nitrogen atoms to form NOx, an air pollutant.

Nitrogen is the most common part of the air we breathe. In fact, about 80% of the air is nitrogen. Normally, nitrogen atoms float around joined to each other like chemical couples. But when air is heated - in a coal boiler's flame, for example - these nitrogen atoms break apart and join with oxygen. This forms "nitrogen oxides" - or, as it is sometimes called, "NOx" (rhymes with "socks"). NOx can also be formed from the atoms of nitrogen that are trapped inside coal.

In the air, NOx is a pollutant. It can cause smog, the brown haze you sometimes see around big cities. It is also one of the pollutants that forms "acid rain." And it can help form something called "groundlevel ozone," another type of pollutant that can make the air dingy.

NOx can be produced by any fuel that burns hot enough. Automobiles, for example, produce NOx when they burn gasoline. But a lot of NOx comes from coal-burning power plants, so the Clean Coal Technology Program developed new ways to reduce this pollutant.

One of the best ways to reduce NOx is to prevent it from forming in the first place. Scientists have found ways to burn coal (and other fuels) in burners where there is more fuel than air in the hottest combustion chambers. Under these conditions, most of the oxygen in air combines with the fuel, rather than with the nitrogen. The burning mixture is then sent into a second combustion chamber where a similar process is repeated until all the fuel is burned.

This concept is called "staged combustion" because coal is burned in stages. A new family of coal burners called "low-NOx burners" has been developed using this way of burning coal. These burners can reduce the amount of NOx released into the air by more than half. Today, because of research and the Clean Coal Technology Program, approximately 75 percent of all the large coal-burning boilers in the United States will be using these types of burners.

There is also a family of new technologies that work like "scrubbers" (> see the previous page) by cleaning NOx from the flue gases (the smoke) of coal burners. Some of these devices use special chemicals called "catalysts" that break apart the NOx into non-polluting gases. Although these devices are more expensive than "low-NOx burners," they can remove up to 90 percent of NOx pollutants.  

But in the future, there may be an even cleaner way to burn coal in a power plant. Or maybe, there may be a way that doesn't burn the coal at all.

BACK  GO BACK

READ ON  FORWARD

 

Dr. H. Carbon asks:  How many U.S. coal-burning power plants use Clean Coal Technologies?
NONE

None

ABOUT HALF

About half

THREE FOURTHS

More than 3/4ths

ALL OF THEM

All of them

Click on your choice

 Page owner:  Fossil Energy Office of Communications
Page updated on: March 29, 2011 

The White House USA.gov E-gov IQ FOIA Privacy Program
U.S. Department of Energy | 1000 Independence Ave., SW | Washington, DC 20585
1-800-dial-DOE | f/202-586-4403 | e/General Contact

Web Policies | No Fear Act | Privacy | Phone Book | Accessibility